*** Booting Zephyr OS build v3.1.99-ncs1  ***
*** BoSLcam firmware v1.7.0rc complied on May 16 2026 at 20:46:31 ***
[00:00:00.554,962] [0m<inf> modem: shutdown decrementer worker active[0m
[00:00:00.554,962] [0m<inf> modem: semaphore eater sleeping for: 28800 s[0m
[00:00:01.554,992] [0m<inf> watchdog: Watchdog timeout installed. Timeout: 86400[0m
[00:00:01.555,023] [0m<inf> watchdog: Watchdog started[0m
[00:00:01.555,023] [0m<inf> watchdog: Enabled watchdog success![0m
[00:00:01.555,053] [0m<inf> main: Enabled wke interrupt success![0m
[00:00:03.559,570] [0m<inf> sd: Detected SD card[0m
[00:00:03.601,593] [0m<inf> sd: Maximum SD clock is under 25MHz, using clock of 8000000Hz[0m
[00:00:03.624,420] [0m<inf> sdhc: config parsed with result 0[0m
============ CONFIG ============
image_config_t
	auto_range_time            = 10000
	resolution                 = QVGA
	format                     = BMP
	flash                      = 255
	use_flash                  = 1
	aec            [00:00:10.208,221] [0m<inf> modem: COPS ok[0m
[00:00:10.208,770] [0m<inf> modem: CREG: registered, 5[0m
[00:00:10.209,289] [0m<inf> main: busy wait for valid time[0m
[00:00:10.219,390] [0m<inf> watchdog: fed[0m
[00:00:10.219,879] [0m<inf> main: ov7675 initialisation[0m
[00:00:10.219,879] [0m<inf> ov7675: bind gpio@842500
[0m
[00:00:10.219,909] [0m<inf> ov7675: bind I2C2
[0m
[00:00:10.820,098] [1;31m<err> i2c_nrfx_twim: Error on I2C line occurred for message 0[0m
[00:00:21.010,192] [0m<inf> main: ov7675 capture[0m
[00:00:21.320,129] [0m<inf> ov7675: ready
[0m
[00:00:32.753,570] [1;31m<err> fs: file close error (-5)[0m
[00:00:32.756,195] [0m<inf> main: mean_rgb: 27[0m
[00:00:32.756,195] [0m<inf> main: ov7675 deinit[0m
[00:00:32.756,195] [0m<inf> main: image -> sdhc[0m
[00:00:42.806,823] [1;31m<err> fs: failed to rename file or dir (-5)[0m
[00:00:42.806,854] [0m<inf> main: status -> sdhc[0m
[00:00:52.781,188] [1;31m<err> fs: file close error (-5)[0m
[00:00:52.781,219] [0m<inf> main: status -> ftp[0m
[00:00:52.781,219] [0m<inf> ftp: modem begin[0m
[00:00:52.787,872] [0m<inf> modem: AT initialised[0m
[00:00:52.788,543] [0m<inf> modem: XSYSTEMMODE read ok[0m
[00:00:52.795,349] [0m<inf> modem: CFUN on ok[0m
[00:00:52.795,379] [0m<inf> modem: Registration attempt to: 50501[0m
[00:00:52.795,959] [0m<inf> modem: COPS ok[0m
[00:00:52.796,447] [0m<inf> modem: CREG: registered, 5[0m
[00:00:52.796,936] [0m<inf> ftp: register ok[0m
220---------- Welcome to Pure-FTPd [privsep] [TLS] ----------
220-You are user number 4 of 50 allowed.
220-Local time is now 21:47. Server port: 21.
220-This is a private system - No anonymous login
220-IPv6 connections are also welcome on this server.
220 You will be disconnected after 15 minutes of inactivity.
504 Unknown command
[00:00:55.480,621] [0m<inf> ftp: open ok[0m
331 User images2024@bosl.com.au OK. Password required
230 OK. Current restricted directory is /
[00:00:56.761,596] [0m<inf> ftp: login ok[0m
550 Can't create directory: File exists
[00:00:59.013,610] [0m<inf> ftp: mkdirs ok[0m
200 TYPE is now 8-bit binary
[00:00:59.640,563] [0m<inf> ftp: type binary ok[0m
227 Entering Passive Mode (103,20,200,161,217,204)
150 Accepted data connection
226-File successfully transferred
226 0.008 seconds (measured here), 7.05 Kbytes per second
[00:01:01.587,677] [0m<inf> ftp: put ok[0m
[00:01:01.587,677] [0m<inf> ftp: closing...[0m
[00:01:02.587,646] [1;31m<err> ftp_client: POLLHUP[0m
901 Disconnected(-104).
[00:01:02.588,317] [0m<inf> main: done[0m
[00:01:02.588,317] [0m<inf> main: time sleep[0m
[00:01:02.588,348] [0m<inf> main: Sleeping for: 3537412 ms[0m
