*** Booting Zephyr OS build v3.1.99-ncs1  ***
*** BoSLcam firmware v1.7.0rc complied on May 16 2026 at 20:46:31 ***
[00:00:00.555,084] [0m<inf> modem: shutdown decrementer worker active[0m
[00:00:00.555,084] [0m<inf> modem: semaphore eater sleeping for: 28800 s[0m
[00:00:01.555,114] [0m<inf> watchdog: Watchdog timeout installed. Timeout: 86400[0m
[00:00:01.555,145] [0m<inf> watchdog: Watchdog started[0m
[00:00:01.555,145] [0m<inf> watchdog: Enabled watchdog success![0m
[00:00:01.555,175] [0m<inf> main: Enabled wke interrupt success![0m
[00:00:03.559,692] [0m<inf> sd: Detected SD card[0m
[00:00:03.601,745] [0m<inf> sd: Maximum SD clock is under 25MHz, using clock of 8000000Hz[0m
[00:00:03.624,694] [0m<inf> sdhc: config parsed with result 0[0m
[00:00:03.624,725] [0m<inf> sdhc: CONFIG:[0m
[00:00:03.624,755] [0m<inf> sdhc: TRIG: type=TIME_TRIGGER interval=3600000 decim=1 dark=30[0m
[00:00:03.624,786] [0m<inf> sdhc: IMG: fmt=BMP res=QVGA flash=255 use_flash=1 aec=ON exp=100 ag[00:00:09.683,288] [0m<inf> modem: COPS ok[0m
[00:00:09.683,807] [0m<inf> modem: CREG: registered, 5[0m
[00:00:09.684,356] [0m<inf> main: busy wait for valid time[0m
[00:00:09.694,427] [0m<inf> watchdog: fed[0m
[00:00:09.694,915] [0m<inf> main: ov7675 initialisation[0m
[00:00:09.694,915] [0m<inf> ov7675: bind gpio@842500
[0m
[00:00:09.694,946] [0m<inf> ov7675: bind I2C2
[0m
[00:00:10.295,135] [1;31m<err> i2c_nrfx_twim: Error on I2C line occurred for message 0[0m
[00:00:20.485,198] [0m<inf> main: ov7675 capture[0m
[00:00:20.795,532] [0m<inf> ov7675: ready
[0m
[00:00:32.230,041] [1;31m<err> fs: file close error (-5)[0m
[00:00:32.232,666] [0m<inf> main: mean_rgb: 30[0m
[00:00:32.232,696] [0m<inf> main: ov7675 deinit[0m
[00:00:32.232,696] [0m<inf> main: image -> sdhc[0m
[00:00:42.272,949] [1;31m<err> fs: failed to rename file or dir (-5)[0m
[00:00:42.272,979] [0m<inf> main: status -> sdhc[0m
[00:00:52.253,173] [1;31m<err> fs: file close error (-5)[0m
[00:00:52.253,204] [0m<inf> main: image -> ftp[0m
[00:00:52.253,234] [0m<inf> ftp: modem begin[0m
[00:00:52.259,643] [0m<inf> modem: AT initialised[0m
[00:00:52.260,314] [0m<inf> modem: XSYSTEMMODE read ok[0m
[00:00:52.267,120] [0m<inf> modem: CFUN on ok[0m
[00:00:52.267,150] [0m<inf> modem: Registration attempt to: 50501[0m
[00:00:52.267,730] [0m<inf> modem: COPS ok[0m
[00:00:52.268,218] [0m<inf> modem: CREG: registered, 5[0m
[00:00:52.268,707] [0m<inf> ftp: register ok[0m
220---------- Welcome to Pure-FTPd [privsep] [TLS] ----------
220-You are user number 4 of 50 allowed.
220-Local time is now 21:07. Server port: 21.
220-This is a private system - No anonymous login
220-IPv6 connections are also welcome on this server.
220 You will be disconnected after 15 minutes of inactivity.
504 Unknown command
[00:00:55.053,527] [0m<inf> ftp: open ok[0m
331 User images2024@bosl.com.au OK. Password required
230 OK. Current restricted directory is /
[00:00:56.335,601] [0m<inf> ftp: login ok[0m
550 Can't create directory: File exists
550 Can't create directory: File exists
[00:00:57.623,626] [0m<inf> ftp: mkdirs ok[0m
200 TYPE is now 8-bit binary
[00:00:58.243,682] [0m<inf> ftp: type binary ok[0m
227 Entering Passive Mode (103,20,200,161,208,245)
150 Accepted data connection
226-File successfully transferred
226 39.151 seconds (measured here), 3.83 Kbytes per second
227 Entering Passive Mode (103,20,200,161,192,248)
150 Accepted data connection
226-File successfully transferred
226 0.008 seconds (measured here), 8.03 Kbytes per second
[00:01:42.094,696] [0m<inf> ftp: put ok[0m
[00:01:42.094,726] [0m<inf> ftp: FTP STATUS: closing...[0m
[00:01:42.743,377] [1;31m<err> ftp_client: POLLHUP[0m
901 Disconnected(-104).
[00:01:42.743,957] [0m<inf> main: status -> ftp[0m
[00:01:42.743,957] [0m<inf> ftp: modem begin[0m
[00:01:42.744,506] [0m<inf> modem: AT initialised[0m
[00:01:42.745,056] [0m<inf> modem: XSYSTEMMODE read ok[0m
[00:01:42.745,941] [0m<inf> modem: CFUN on ok[0m
[00:01:42.745,971] [0m<inf> modem: Registration attempt to: 50501[0m
[00:01:42.746,917] [0m<inf> modem: COPS ok[0m
[00:01:42.747,406] [0m<inf> modem: CREG: registered, 5[0m
[00:01:42.747,955] [0m<inf> ftp: register ok[0m
220---------- Welcome to Pure-FTPd [privsep] [TLS] ----------
220-You are user number 4 of 50 allowed.
220-Local time is now 21:08. Server port: 21.
220-This is a private system - No anonymous login
220-IPv6 connections are also welcome on this server.
220 You will be disconnected after 15 minutes of inactivity.
504 Unknown command
[00:01:44.645,416] [0m<inf> ftp: open ok[0m
331 User images2024@bosl.com.au OK. Password required
230 OK. Current restricted directory is /
[00:01:45.930,511] [0m<inf> ftp: login ok[0m
550 Can't create directory: File exists
[00:01:46.565,521] [0m<inf> ftp: mkdirs ok[0m
200 TYPE is now 8-bit binary
[00:01:47.204,498] [0m<inf> ftp: type binary ok[0m
227 Entering Passive Mode (103,20,200,161,229,160)
150 Accepted data connection
226-File successfully transferred
226 0.008 seconds (measured here), 7.03 Kbytes per second
[00:01:49.133,605] [0m<inf> ftp: put ok[0m
[00:01:49.133,636] [0m<inf> ftp: closing...[0m
[00:01:49.765,686] [1;31m<err> ftp_client: POLLHUP[0m
901 Disconnected(-104).
[00:01:49.766,143] [0m<inf> main: done[0m
[00:01:49.766,174] [0m<inf> main: time sleep[0m
[00:01:49.766,174] [0m<inf> main: Sleeping for: 3490234 ms[0m
